Shopping Cart
0 items
 

Hair Care Instructions

Hair  Extensions Care Instructions

Shampooing

Conditioning

Styling

Longevity

U Part Wig Care Instructions

Making the Cap fit Smaller

Lace Wig Care Instructions

Preparing Lace Wig for Application

Preparing Skin and Hair for Application

Application Routine #1: (for those using liquid adhesives)

Application Routine #2 (for those who use tape):

Removal of Your Lace Wig

Specs

Color Chart

Texture Chart

Wig and Toupee Sizing Chart

Hair  Extensions Care Instructions

Shampooing

Select an appropriate shampoo for your hair type and the extensions. A qualified professional hair stylist can help you with this.

Before washing your human hair extensions, it is best to gently comb it out to remove any tangles. Please wash with cold water. Wet your hair normally. Pour the shampoo into your hand and then apply to your hair. Massage gently. Be sure to rinse your hair thoroughly.

Wash your hair at least 1-2  times per week to eliminate product build-up and tangles. Wash and conditon the hair in the same direction as not to cause tangles. Use a clarifying shampoo to remove product build up. For normal washing Organix Moroccan oil products and Creme of Natural Argan oil products work good with the hair.


Conditioning

Select an appropriate conditioner for your hair type and the extensions. Dryness can be a challenge and it is important to keep your hair moisturized to keep your hair soft and shiny and to prevent damage.

Apply conditioner to the middle and ends of your hair. Do not apply to the scalp or where the extensions are attached to your hair. Gently work the conditioner into your hair and leave on for five minutes. If your hair is prone to tangles, use a wide-toothed comb to gently work them out while the conditioner is still in your hair. Rinse your hair well with luke warm water.

Deep condition your extensions to make the hair shiny and vibrant. Please follow instructions on the conditioner as not to over condition the hair.

Dry your hair by blotting with a towel. Do not rub. If you blow dry your hair, try to keep the dryer as far away from your hair as possible and minimize the heat. Use a heat protectant. Blow dryer comb attachments are not recommended.


Styling

After washing and conditioning apply a good spray leave on conditioning product. Use this product to freshen the hair between washing. Always leave leave-in conditioner or lightweight oil on the hair so that it will not dry out.

Wash your hair immediately after swimming, spa, exercise, etc. Hair will typically become tangled when dirt and sweat accumulate.

Too much leave-in conditioner and other hair care products will create a build up on the hair causing it to tangle faster. Use a clarifying shampoo to remove product build-up.

Longevity

To help the hair last as long as possible it is important to seal the wefts using an adhesive. If you are doing a sew-in installation it is important to sew-around the wefts and not sew through the wefts. Do not cut the wefts during installation unless its absolutely necessary. The fold-over method is recommended. If you do cut the wefts it is important to seal the ends of the weft. Too much oil on the wefts themselves will break down the weft sealant so keep scalp clean and wefts clean. It is important to use a heat protectant if you plan on heat styling the hair. There are many methods to repairing damaged hair including microwaving with conditioner, bleach baths, and silicon mix. Instructions on these methods can also be found on youtube.



U Part Wig Instructions

How to make wig fit smaller

If you receive your wig and it fits too small there is an easy way to make it snug. It most cases adding a small piece of elastic adjusts the fit.

 

 

 

Lace Wig Care Instructions

Preparing Lace Wig for Application:

  1. Clip all hair and baby hair away from the edge of the wig. This will prevent the hair from getting stuck in the glue when applying the unit.
  2. Cautiously cut the lace around the entire hairline. You may cut all the lace off or you can leave a little of the lace if you feel more comfortable doing so. **Make sure all baby hair is carefully pinned back so it is not cut.
  3. *OPTIONAL*: When you have completed cutting the lace around the entire perimeter, you can spray "Fray Block" on the edge of the lace to prevent it from fraying. (Please be sure to use this sparingly, because it can try white if you use too much.)

Preparing Skin and Hair for Application:

  1. Wash , condition and dry your hair. After your hair is dried either braid hair in small cornrows, or tightly wrap your hair for a flat look.
  2. Wash your face completely. Then using cotton balls, use alcohol to clean around your entire hairline, to remove any oil that may be on your skin.
  3. *OPTIONAL* Apply scalp protector or liquid band aid to prevent skin from adhesives. This will act as a barrier between your skin and the adhesive. (This step is very important for those who workout, swim or those with sensitive skin.)
  4. *RECOMMENDED* For those with hair, put on a flesh-toned wig cap, and line it up with your hairline, so it is completely covered. This will work as a protective layer for your hair, and will also create a scalp illusion under your hairline. (Make sure the wig cap is pulled taught onto your hairline.) FYI: To prevent the wig cap from slipping, allow the glue and/or tape to overlap onto the nylon stocking cap or loosely stitch the cap in place.

Application Routine #1: (for those using liquid adhesives)

  1. Start with a Q-Tip or a small make-up brush and apply a thin coat of the glue around the perimeter of your hairline. Use the liquid adhesives sparingly; using a lot of the adhesive will add to the drying time. Soft bond adhesives (I.e.: Vapon No-Tape, Ultra-Hold and Invisi-bond) must dry or get tacky . To aide the drying time, use a hand held blowdryer on a cool/warm setting until dry or tacky. *Do NOT bond lace wig to wet glue, the wig will not set properly and will not stick well. Hard bond adhesives (I.e.: Endurabond, Dermabond and Base bond) do NOT require any drying time, since they dry immediately after it is applied.
  2. After your glue is ready for application, you must position the lace wig on your head. To make sure it is aligned properly, you must first bond the wig at the center of your front hairline. (The center point can be determined by parting the hair down the middle and aligning it with the center of your forehead or widows peak.) Then going from one side to the other, press the edge of the wig down into the adhesive using a fine tooth comb. *FYI* If you made an error when applying use a Q-Tip and alcohol between the lace and your skin to release and reapply the wig.
  3. Double check your hairline and touch-up any areas where the wig is not applied securely. If you need to remove any excess glue use a Q-Tip and the corresponding solvent.
  4. When you have completed the application process, tie down your hairline with a silk or satin scarf. This will allow the glue to set and dry properly. You may also sit under a dryer during this step to aide in the drying process.
  5. *IMPORTANT* For those who want to use a tape and glue combination, the glue should go on your skin and the tape should go on the lace. This will actually protect the lace from the wear and tear of the liquid adhesives.
  6. For those who want an even stronger hold, you may apply glue on the tape as well, just be cautious.

Application Routine #2 (for those who use tape):

  1. Make sure your skin, hair and wig are clean and dry. (Follow the “Preparing Wig and Skin for Application” instructions.)
  2. Cut the tape into desired shapes, you want the tape to contour your hairline.
  3. Peel the paper from one side of the double-sided tape and apply the strips of tape around the perimeter of the lace wig. Press firmly into place. *IMPORTANT* You should leave small spaces between the tape to allow for water to escape, if you will be wearing this for extended periods of time.
  4. Position the lace wig on head, and starting with the center, go from side to side, pressing the wig down in sections with a fine tooth comb. Press firmly, for a
  5. When you have completed the application process, tie down your hairline with a silk or satin scarf. This will allow the glue to set and dry properly. You may also sit under a dryer during this step to aide in the drying process.

Removal of Your Lace Wig

  1. It is very important to allow the adhesive remover to completely saturate and the lace to release prior to trying to remove the unit. This will preserve the lace on your unit and your hairline. PLEASE take your time while doing this.
  2. Spray your adhesive remover on top of the glue and lace.
  3. Wait for the unit to completely release. You may also use a Q-Tip to apply the remover/solvent between the lace and your skin.
  4. *IMPORTANT* You want the glue to remain on your skin, not the lace.
  5. Use adhesive remover/solvent to clean the adhesive from your skin.
  6. Wash lace wig to clean and remove any glue residue that might be on the lace and in the hair of the wig.

Specs

Color Chart


Texture Chart

Bodywave, Deepwave, Italian Wave, New Deep Wave

Wig and Toupee Sizing Chart

Small

Circumference: 21-21.5"
Front-to-Nape: 13"
Ear-to-Ear (across forehead): 11.5"
Ear-to-Ear (over top of head): 11.5"
Temple-to-Temple: 13"
Nape of Neck: 4"

Medium

Circumference: 22-22.5"
Front-to-Nape: 14"
Ear-to-Ear (across forehead): 12.5"
Ear-to-Ear (over top of head): 12.5"
Temple-to-Temple: 14"
Nape of Neck: 5"

Large

Circumference: 23-23.5"
Front-to-Nape: 15"
Ear-to-Ear (across forehead): 13"
Ear-to-Ear (over top of head): 13"
Temple-to-Temple: 15"
Nape of Neck: 6"


bottom